1 Clean away any remnants of earlier painting.

2 Clean the glued elements carefully, dust and degrease with denatured alcohol.

3 Cut off the tip of the cartridge and attach the dispensing spout.

4 Apply the adhesive in points or stripes on the substrate or the element being glued.

5 Fit the surfaces together as best as possible.

6 Bond the glued elements, then press firmly and evenly.

7 If there are tensions, the elements shall be immobilized until fully cured.

8 After completing the work, close tightly the packaging with glue.

1 Remove any paint residues.

2 Align the glued surfaces, adjust them to each other, dust and degrease

3 Apply the glue to the element to be glued with a toothed trowel.

4 Glued joint elements and press firmly and evenly.

5 If the elements are under tension or are particularly heavy, immobilise them until the glue fully hardens.

6 Tightly close the package after finishing work.

1 Remove any paint residues.

2 Align the glued surfaces, adjust them to each other, dust and degrease

3 Apply the glue to the element to be glued with a toothed trowel.

4 Glued joint elements and press firmly and evenly.

5 If the elements are under tension or are particularly heavy, immobilise them until the glue fully hardens.

6 Tightly close the package after finishing work.

READ BEFORE USE

Before applying, check the action of the adhesive on the glued elements.

Carry out work at temperature (10÷30)°C.

The temperature range of works concerns the temperature of air, substrate and glued elements.

At least one of the glued surfaces must be porous and absorbent.

The full strength of bond is obtained after approx. 24 h.

Clean dirty tools and remove fresh stains with warm water.

Remove dried dirt with an appropriate implement.

READ BEFORE USE

Before applying, check the action of the adhesive on the glued elements.

Carry out work at temperature (10÷30)°C.

The temperature range of works concerns the temperature of air, substrate and glued elements.

At least one of the glued surfaces must be porous and absorbent.

The full strength of bond is obtained after approx. 24 h.

Clean dirty tools and remove fresh stains with warm water.

Remove dried dirt with an appropriate implement.

READ BEFORE USE

Before applying, check the action of the adhesive on the glued elements.

Carry out work at temperature (10÷30)°C.

The temperature range of works concerns the temperature of air, substrate and glued elements.

At least one of the glued surfaces must be porous and absorbent.

The full strength of bond is obtained after approx. 24 h.

Clean dirty tools and remove fresh stains with warm water.

Remove dried dirt with an appropriate implement.